Details of the sand making machine installation
Tarzan as a professional manufacturer of sand making machine, is familiar with each structural component of sand making machine.
Given some sand and gravel manufacturer of such knowledge is indeed
very scarce, following our engineers will introduce installation details
and procedures about sand making machine.
When install a sand making machine, be sure to check the equipment installation site, as well as standby equipment to be installed. only to ensure all that ready fully, can we ensure there were no problems in the later installation process. The following is the most professional knowledge.
1. Check into the size and location of the deviation of the discharge port and casting quality: clean surface, free of grease, debris, but does not allow leakage reinforced concrete bare on the outside, and the missing angle of crack.
2. The basis of the size and position deviation should be in accordance with the following criteria: view the coordinates of Dimensions based position measurement requirements of vertical and horizontal axis error is less than 20mm, different parallel to the surface of the standard height of less than 20mm: should be less than the full length of the gradient error 20mm, the upper surface roughness should be less than 5mm, the discharge end and the data allows only negative is not allowed to.
3. Acceptance of the equipment, the staff in accordance with the packing slip, all the size of the parts and documents, check to see if the lack of deformation, the data do record.
4 Before installation, clear the packaging protective film and dust oil, pre-test and pre-assemble components and critical mating parts, in order to avoid rework in the installation work, ensure the progress and quality of the installation.
http://rock-crushers.com/
http://www.trituradoradepiedra.com.es/
http://www.sandmakingsystem.com/
http://stonecrushermachine.net/
http://jawcrushermachines.com/
When install a sand making machine, be sure to check the equipment installation site, as well as standby equipment to be installed. only to ensure all that ready fully, can we ensure there were no problems in the later installation process. The following is the most professional knowledge.
1. Check into the size and location of the deviation of the discharge port and casting quality: clean surface, free of grease, debris, but does not allow leakage reinforced concrete bare on the outside, and the missing angle of crack.
2. The basis of the size and position deviation should be in accordance with the following criteria: view the coordinates of Dimensions based position measurement requirements of vertical and horizontal axis error is less than 20mm, different parallel to the surface of the standard height of less than 20mm: should be less than the full length of the gradient error 20mm, the upper surface roughness should be less than 5mm, the discharge end and the data allows only negative is not allowed to.
3. Acceptance of the equipment, the staff in accordance with the packing slip, all the size of the parts and documents, check to see if the lack of deformation, the data do record.
4 Before installation, clear the packaging protective film and dust oil, pre-test and pre-assemble components and critical mating parts, in order to avoid rework in the installation work, ensure the progress and quality of the installation.
http://rock-crushers.com/
http://www.trituradoradepiedra.com.es/
http://www.sandmakingsystem.com/
http://stonecrushermachine.net/
http://jawcrushermachines.com/
评论
发表评论